Installation Guide

Installing Your ParkGuard

Takes 5 minutes. No experience needed.

If you can hang a picture on the wall, you can install ParkGuard. The whole process is just drilling 3 holes and tightening 3 bolts. Most people are done in the time it takes to drink a coffee.

What you'll need

Everything important comes in the box — expansion bolts, remotes, cover keys, and a full manual. The only thing you need to grab from your garage is:

  • A drill with a masonry bit (the kind for drilling into concrete)
  • A hammer

That's it. No electrician, no wiring, no special skills.

Check your spot first

ParkGuard anchors into solid concrete or asphalt. Gravel, dirt, grass, and loose pavers won't hold the anchor bolts — if your spot isn't paved, add a small concrete pad first. And if the spot is on a public street, rented, or in an HOA community, check with your city, landlord, or HOA before you drill: it's your spot, but it may not be your pavement.

The 5 steps

  1. Pick your spot

    Place ParkGuard where you want it — usually centered in your parking space. When it's lowered flat, your car drives right over it.

  2. Mark and drill

    Mark the 3 bolt holes through the base of the unit. Move it aside and drill straight down. The included anchors show you the exact depth.

  3. Tap in the anchors

    Drop the expansion anchors into the holes and give each one a quick tap with a hammer until it sits flush.

  4. Bolt it down

    Set ParkGuard back over the holes, drop in the expansion bolts, and tighten them down. Done in under a minute.

  5. Pop in the batteries and pair the remote

    Slide in 3 standard D batteries (not included), press and hold the pair button on the unit, then press any button on the remote. You'll hear a beep — that means you're paired and ready to go.

Test it

Press the remote button once. Watch ParkGuard fold down flat. Press it again — it stands back up. That satisfying click is the sound of your spot being yours forever.

Batteries & troubleshooting

  • Replacing the batteries

    ParkGuard runs on 3x standard D batteries in the weather-sealed compartment you used in step 5. A set lasts weeks of daily use, and the low-battery indicator warns you well before they run out. Swapping them takes a minute and needs no tools.

  • Remote not responding?

    Try fresh batteries first — in the unit and in the remote. If it still won't respond, re-pair them: press and hold the pair button on the unit, then press any button on the remote until you hear the beep. And remember the 65 ft range works best with a clear line of sight.

  • Batteries died while the barrier is up?

    Use the cover keys included in the box to lower the barrier manually, then drop in fresh batteries and you're back to one-press control.

  • Alarm went off?

    The built-in alarm triggers when the barrier is forced. Check your spot, then reset it by raising or lowering the barrier with the remote. The included manual covers the alarm in more detail.

Stuck on something else? Email support.parkguard@gmail.com — most questions are answered the same day.

Need a hand?

Every ParkGuard comes with a printed manual, and our team is one email away if you get stuck. Reach out at support.parkguard@gmail.com — most installation questions are answered the same day.

30-day money-back guarantee. If anything isn't right, we make it right.

Get ParkGuard